During the end of the June, images were seen that were suppose to be the rear housing of the Apple iPhone 6s. The only visible difference noted was the changed position of mounting points of the motherboard of the handset. Now new pics of the rear housing of Apple iPhone 6 are seen. Once again minor differences were noted when inside of the rear housing was compared with the current model.
A visible change noted in the housing of the Apple iPhone 6s Plus was the higher position of the screw hole for the speaker. This indicates that the model will have a whole new speaker module. Other than that, use of a different material for making the rear housing was also noted. According to the source, stronger material is used for making the housing of the handset. Therefore, the device will not be getting bent. One cannot forget the #bendgate controversy that started after different iPhone 6 Plus users found that their devices had actually bent in their rear pockets.
Previous reports had disclosed that Apple is planning to use the same Series 7000 Aluminium that was used on the Apple Watch. The reason behind it was to prevent the next iteration of iPhone from bending. This aluminium is an aircraft grade aluminium which should be able to hold up to just anything that the device encounters during the course of its life cycle.
There are different such photos surfacing the web now a days. The images show the possible changes in the casing for Apple iPhone 6s Plus. However, this information is not complete so one can expect more changes in the coming days.